
PenMount for Fedora Core 8

=======================================================================
 Overview
=======================================================================
  The following versions of Fedora has been tested.

  Fedora             Linux kernel            X window
  -------------------------------------------------------------
 
  Core 8             2.6.23.1-42.fc8        X Window System 1.3.0


  The following control board was supported.

  Control Board                 Port            Description
  --------------------------------------------------------------
  PenMount 9000 series	        Serial          19200/9600 bps
  PenMount 5000 series          USB             low speed

  PemMount 6000 series          Serial          19200/9600 bps
                                USB             full speed

=======================================================================
 Quick Install
=======================================================================
  1. Login as root in Fedora login prompt

  2. Change directory
     $ cd pmlinux-fedora

  3. Install
     $ ./install.sh

  4. Reboot

=======================================================================
 How to Calibrate PenMount
=======================================================================
  1. Login as root

  2. Make sure that the SELinux System Default Enforcing Mode is disabled.

  3. Change directory
     $ cd pmlinux-fedora

  4. run gCalib
     $ ./gCalib 4
     4 is the calibration number.
     Available calibration numbers are 0, 4, 9, 16, 25.

  5. Do calibration
     Touch the red points appear on screen until calibration process complete.

  6. After the calibration complete, the parameters are stored in the following location :
     /etc/penmount.dat.

=======================================================================
 FAQ
=======================================================================
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Problem :
The PenMount Calibration program gCalib freezes after I touch the last red point, what should I do?

Solution :
1. run SELinux Management
   located at Applications->System Tools->SELinux Management

2. The default settings of System Default Enforcing mode is "Enforcing".
   Change the setting to "Disabled"

3. Reboot the system.
   System will automatically apply the calibration settings after reboot.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~


PenMount
Febuary 28, 2008

